Qualectron - QT100X, the optimal PCB repair & pcb diagnostic system

In-circuit Functional Tester with TTL and CMOS Logic
for PCB Repair and Troubleshooting Applications

Qmax QT100X Features

Standard test library for TTL and CMOS logic families
Power ON true digital and analog functional testing in-circuit and
out-circuit
Automatic pass / fail analysis for the device under test (DUT)
Unknown device idenification to seek unmarked devices
Loop test to isolate intermittently failing devices
In-circuit resistance and capacitance measurement
Automatic pull-up and pull-down resistors for multi-block device testing
Powerful in-built Short Circuit locator catering for 200 milliohms, 2 ohms and 20 ohms ranges
Automatic BUT power control
Powerful waveform display for comparision with the evaluation engine and the output
Versatile Clipstatus Display with voltage / dynamic impedance / label display
Comprehensive data display on-demand, for device under test
Powerful board learning and testing, for improved debugging of faulty boards
Card edge testing with the powerful IDDE Software, limited to digital devices
Powerful QSM techniuqe for improved coverage, when the function of the device is unknown
DEF 0053/1 compliance for the safe operating limits on backdriving

Specification
Digital

Basic 48 channels of digital drivers with programmable thresholds,
expandable to a maximum of 256 channels
220 mA sink / source per channel
0 V / 5 V drive levels
Maximum 20 ns skew between channels
500 KHz data rate or 250 KHz clock rate maximum
8192 deep by 2 bits RAM behind each pin
Programmable time base to accomodate slower devices
8 programmable guard channels

Analog

2 analog channels can be connected to any of the channels
8 bit resolution in 2.5 V, 5 V, 8 V, 19 V and 32 V ranges
8192 depth by 8 bits behind each channel
Selectable drive source impedance of 50 ohm, 200 ohm, 1K ohm,
10K ohm and 100K ohm
± 10 milliamps per channel maximum
Choose the drive pattern from sine, cosine, tangent, square, triangular and
ramp with programable amplitude, phase and frequency

QSM

QSM is a propritary test technique developed by Qmax, to effectively debug boards
with no information about the devices being used

Applications